CTC Union ETU01C Manuel d'utilisateur télécharger pdf (Page 29)

Chapter 3 Provisioning

6. Configure and Verify Remote ET100R router module.

CLI commands: (must be in enable)

config system name Remote

config interface eth1 off

config interface eth1 ip 0 addr 192.168.0.254 netmask 255.255.255.0

config interface hdlc1 off

config interface hdlc1 encap cisco

config interface hdlc1 ip 0 addr 10.0.0.2 netmask 255.255.255.252

config interface hdlc1 on

config interface hdlc1 ip 0 peer 10.0.0.1

config ip rip ifadd eth1

config ip rip ifadd hdlc1

config ip rip on

config ip rip version 1

config save

reboot

Note: You may type configuration commands to a text file, copy them and paste them into HyperTerminal and it will

"run" similar to a run-config-script. Please refer to the scripts folder on the CDROM for many pre-written scripts.

(Please confirm the settings by using commands below after ET100R boots up.)

show interface summary

show ip route

ping 192.168.1.254 ---- This should successfully ping to PC in LAN A.

ping 10.0.0.1 ---- This should successfully ping to WAN I/F in ET100R located in LAN A.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 79 80

Pas de commentaire

CTC Union ETU01C Manuel d'utilisateur Page 29