CTC Union SHDSL Manuel d'utilisateur Page 55
- Page / 96
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
55
Configured 0.0.0.0 will allow all hosts on
Internet or LAN to access the router.
Leaving blank of trust host list will cause
blocking all PC from WAN to access the router.
On the other hand, only PC in LAN can
access the router.
If you type the excact IP address in the filed,
only the host can access the router.
Click Finish to finish the setting.
The browser will prompt the configured parameters and check it before writing into EPROM.
Press Restart to restart the gateway working with the new parameters and press Continue to setup
other parameters.
9.2 SNMP
Simple Network Management Protocol (SNMP) provides for the exchange of
messages between a network management client and a network management
agent for remote management of network nodes. These messages contain
requests to get and set variables that exist in network nodes in order to obtain
statistics, set configuration parameters, and monitor network events. SNMP
communications can occur over the LAN or WAN connection.
The router can generate SNMP traps to indicate alarm conditions, and it relies
on SNMP community strings to implement SNMP security.
This router support MIB I and MIB II.
Click SNMP to configure the parameters.
In the table of current community pool, you can setup
the access authority.
In the table of current trap host pool, you can setup
the trap host.
Press Modify to modify the community pool.
- USER MANUAL 1
- SHDTU03b 1
- 1. Descriptions 9
- 1.3 Applications 11
- 2 Your Firewall 12
- Stateful Inspection 13
- 2.1.2 Circuit Gateway 14
- 2.1.3 Application Gateway 14
- 2.2 Denial of Service Attack 15
- 3.2 Frame Specification 17
- 3.1 Specification 17
- 3.3 Applications 18
- PO W ERFAULTDATA AL AR M 19
- 4.1 Front Panel 20
- 4.2 Rear Panel 21
- 4.4 Console Cable 22
- 7 Basic Setup 28
- 7.2 Routing Mode 30
- 7.2.1 DHCP Server 30
- 7.2.2 DHCP Client 31
- 7.2.3 DHCP relay 31
- 7.2.4 PPPoE or PPPoA 32
- 7.2.5 IPoA or EoA 34
- 8 Advanced Setup 36
- 8.2 Bridge 39
- 8.3 VLAN 40
- 8.4 Ethernet 41
- 8.5 Route 42
- 8.6 NAT/DMZ 44
- 8.7 Virtual Server 46
- 8.8 Firewall 47
- SMTP Server 50
- SMTP Client 50
- Firewall 50
- Attacker 51
- 171.16.3.4:6000 10.1.2.3:5150 51
- X11 Server 51
- 8.9 IP QoS 52
- 9 Administration 54
- 9.2 SNMP 55
- 9.3 Time Sync 57
- 10 Utility 58
- 10.3 Upgrade 59
- 10.4 Logout 59
- 10.5 Restart 59
- 11 Status 60
- 12.1 CO side 61
- 12.2 CPE Side 62
- 13.1 CO Side 63
- 13.2 CPE side 64
- Driven Interface 65
- 14.4 Window structure 66
- 14.6 Menu Tree 67
- 14.7 Configuration 69
- 14.8 Status 70
- 14.9 Show 71
- 14.10 Write 72
- 14.11 Reboot 73
- 14.12 Ping 74
- 14.13 Administration 75
- 14.13.1 User Profile 75
- 14.13.2 Security 76
- 14.13.3 SNMP 76
- 14.13.5 SNTP 77
- 14.14 Utility 79
- 14.15 Exit 79
- 14.16 Setup 80
- 14.16.1 Mode 80
- 14.16.2 SHDSL.bis 80
- 14.16.3 WAN 81
- 14.16.4 Bridge 82
- 14.16.5 VLAN 83
- 14.16.6 802.11Q VLAN 83
- 14.16.7 Route 84
- 14.16.8 LAN 86
- 14.16.9 IP share 86
- 14.16.10 NAT 86
- 14.16.11 PAT 88
- 14.16.12 DMZ 89
- 14.16.13 Firewall 89
- 14.16.14 Packet Filtering 90
- 14.16.15 DoS Protection 90
- 14.16.16 IPQoS 91
- 14.16.17 DHCP 92
- 14.16.18 DNS proxy 93
- 14.16.19 Host name 94
- 14.16.20 Default 94
- Transmission Series 96
Produits connexes et manuels pour Mise en réseau CTC Union SHDSL
Mise en réseau CTC Union SHDSL Spécifications
(120 pages)
(120 pages)
Mise en réseau CTC Union FMUX-01A Spécifications
(104 pages)
(104 pages)
Sony MDR-EX32LP manuály
Uživatelské manuály a uživatelské příručky pro Sluchátka Sony MDR-EX32LP.
Poskytujeme 2 manuály pdf Sony MDR-EX32LP ke stažení zdarma podle typů dokumentů: Uživatelský manuál
Commentaires sur ces manuels