CTC Union FMUX04 Manuel d'utilisateur télécharger pdf (Page 25)

Chapter 3. Installation

3-1 FMUX-01Mar 2003

3.1 General

This chapter explains in detail the requirements and procedures for the installation of

the MULTIPLEXER UNIT Standalone/Rack Mount Fiber Optical Multiplexer.

3.2 Site Preparation

Install the MULTIPLEXER UNIT within reach of an easily accessible grounded AC

outlet. The outlet should be capable of furnishing 90 to 250 VAC (20 to 60 VDC for DC

supply). Allow at least 10cm (4 inch) clearance at the rear and front of the MULTIPLEXER

UNIT for signal lines and interface cables.

3.3 Mechanical Assembly

The MULTIPLEXER UNIT is designed for rack mount installation and only requires

1U space (1 3/4") in a standard EIA 19 inch rack. It is highly recommended that the unit be

placed in a rack. The MULTIPLEXER UNIT may or may not be delivered completely

assembled. No provision is made for bolting the MULTIPLEXER UNIT to a tabletop.

Figure 3-1 : Rack mount Installation of the MULTIPLEXER UNIT

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 59 60

Pas de commentaire

CTC Union FMUX04 Manuel d'utilisateur Page 25