CTC Union FMUX04 Manuel d'utilisateur télécharger pdf (Page 32)

Chapter 3. Installation

3-8 FMUX-01Mar 2003

3-5-5 SNMP Feature Removal / Replacement

***CAUTION***

This procedure should only be performed by qualified service personnel. In

addition, all power connections must be removed before attempting to open the case.

1. If the unit is installed in a rack, it must be removed.

2. Follow the procedure in 3-5-3 to remove the top cover.

3. The connector for the SNMP daughter card is just behind the front panel display

connector. Carefully seat the card, ensuring no pins are bent. The three holes in the PCB

should line up with the three stand-offs on the mainboard.

4. Install the three pan-head screws supplied. Tighten firmly, but do not over tighten.

Refer to the photo below.

5. Re-install the top cover.

Figure 3-9 : SNMP daughter card Removal / Replacement

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 59 60

Pas de commentaire

CTC Union FMUX04 Manuel d'utilisateur Page 32