CTC Union FRM220 Manuel d'utilisateur télécharger pdf (Page 43)

3.2.10 Logout

Logging out will ensure that the management session with FRM220-1000MS is terminated. This is especially important if you are using a

public computer to manage the device. Once logged out, a password must be entered to access FRM220-1000MS again.

Click the “OK” button to completely log out. Click the “Cancel” button to return to configuration of FRM220-1000MS.

3.3 Troubleshooting

3.3.1 Factory Default.

Apply power to FRM220-1000MS and allow 25-30 seconds to fully boot. Using a pencil or ball-point pen, press the 'DEFAULT' recessed

push-button switch (located on the face plate) and hold for 6 seconds or more then release. DO NOT POWER OFF; Allow the unit to again

fully reboot (about 25 seconds). The factory default TCP/IP settings are:

IP=10.1.1.1

netmask=255.255.255.0

GW=10.1.1.254

The username and password are both reset to 'admin'.

Additionally, any VLAN, 1Q or Q in Q will be disabled. All ports will be enabled, UTP ports set for auto-negotiation and no bandwidth

limiting on any port.

1 2 ... 38 39 40 41 42 43 44 45 46

Pas de commentaire

CTC Union FRM220 Manuel d'utilisateur Page 43