CTC Union FRM220 Manuel d'utilisateur télécharger pdf (Page 7)

Chapter 1 Introduction

1.1 Welcome

Thank you for choosing FRM220-1000MS Gigabit Ethernet OAM/IP Web Smart Media Converter. Throughout this document, the two

different models of this family will be referred to as FRM220-1000MS or in an abbreviated form as just 1000MS. If you would like to skip right

to the installation of the converter, proceed to Chapter 2.

This manual is used to explain the hardware installation procedures and operation of FRM220-1000MS, and present its capabilities and

specifications. This manual is divided into 3 chapters, the Introduction, Installation, and Provisioning Chapters.

Installers should carefully read the Chapters 1&2, Introduction and Installation. The companion document, FRM220 NMC Configuration

Manual, is also available in electronic format, and is required when this product is used in FRM220 rack with NMC. The divisions in that

manual are intended for use by personnel to answer questions in general areas. Planners and potential purchasers may read the Introduction

to determine the suitability of the product to its intended use; Operating Personnel would use the Console and Web Based Management

Chapters and Appendices to become familiar with the line cards and settings. Network Administrators should read the chapters on Console,

Web Based Management and Trouble Shooting to become familiar with the diagnostic capabilities, network settings and management

strategies for both stand-alone or within the SNMP managed chassis.

1.2 Product Description

FRM220-1000MS is an electrical to optical media converter for Gigabit Ethernet. There are two models, one with fixed optical transceiver

(1000M) and one supporting pluggable SFP transceiver (1000MS). These converters sport embedded stand-alone Web based management

over IP networks as well as IEEE802.3ah OAM for remote in-band management. They are also fully compatible and manageable when placed

in FRM220 managed chassis such as the CH20 or CH08 with NMC card.

FRM220-1000MS is an IEEE802.3ah OAM compliant copper to fiber Gigabit Ethernet solution designed to make conversion between

10/100/1000Base-TX and 100/1000Base-FX with SC, FC ,ST connector (FRM220-1000M) or SFP LC connector (FRM220-1000MS). When

deployed as a stand-alone solution, this media converter incorporates an easy to use Web user interface for operation, administration and

maintenance of both local and remotely connected FRM220-1000MS converters. By offering 802.3ah OAM compliance, this converter can be

linked to any 802.3ah compliant fiber switch and support loop back and dying gasp functions. When placed in our centrally controlled and

managed FRM220 managed rack, all functions of this converter and the remotely connected converter can be configured and monitored via in-

band management, including band-width control, duplex, speed, VLAN configuration and more.

1 2 3 4 5 6 7 8 9 10 11 12 ... 45 46

Pas de commentaire

CTC Union FRM220 Manuel d'utilisateur Page 7