CTC Union SHDSL Manuel d'utilisateur télécharger pdf (Page 84)

5. Configuration with Console Port

This chapter will deal with the details of configuration and operation of this product via console port with terminal emulation

program. The configuration of the SHDSL.bis NTU is performed via a menu-driven embedded software, using a standard ASCII

terminal or a PC running a terminal emulation application connected to the rear panel CONSOLE port.

Windows includes a terminal emulation program called HyperTerminal. Connect the appropriated communication port from the

PC to this device. After the physical connection is made, you are ready to configure this product. Make sure you have

connected the supplied RS-232C serial cable (DB9F to RJ-45 Plug) to the console port on the rear panel of this product.

Run the terminal emulation program such as Hyper Terminal with the following setting:

Emulation: VT-100 compatible

Band rate: 115200, Data bits: 8, Parity: None, Stop Bits: 1, Flow Control: None

The following example uses HyperTerminal, supplied with Windows up until Vista release. It can be found by the start path

Start>All Programs> Accessories> Communication> HyperTerminal. Since HyperTerminal is no longer included with Vista or

Windows 7, please use a free terminal emulation program such as TeraTerm or PuTTY.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 161 162

Pas de commentaire

CTC Union SHDSL Manuel d'utilisateur Page 84