CTC Union SHDSL Manuel d'utilisateur télécharger pdf (Page 20)

Chapter 2. Configuration

2-4

Step 5: Install the SHDSL Router

Caution: To avoid possible damage to this Router, do not turn on the router

before Hardware Installation.

? Connect the power adapter to the port labeled DC-IN on the rear panel

of the product.

? Connect the Ethernet cable.

?If the 1-port router is directly connected to PC or NB, the Ethernet cable

must use a cross over cable. If the 1-port router is connected to hub or

switch, be sure that the hub or switch supports auto-sensing. If the HUB

or Switch supports auto-MDIX, then both cross over and non cross over

Ethernet cables are suitable. Otherwise, only straight through Ethernet

cables may be used. The 4-port router has its own auto-MDIX switching

hub so both straight through and cross-over Ethernet cables may be used.

? Connect the phone cable to the SHDTU03 and the other side of phone

cable to wall jack.

? Connect the power adapter to power source.

? Turn on the PC or NB which is used for configuration of the Router.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 89 90

Pas de commentaire

CTC Union SHDSL Manuel d'utilisateur Page 20