CTC Union FRM220 Manuel d'utilisateur télécharger pdf (Page 8)

1.3 Product Features

 Auto-Cross over for MDI/MDIX at UTP port

 Auto-Negotiation or Forced Manual mode for UTP port

 Supports Dual Rate (100/1000) SFP for selectable Fast or Gigabit speed on fiber

 Supports 802.3X flow control Enable or Disable

 Supports Jumbo Frames up to 9K bytes

 Supports 16 Tag VLAN Groups

 Supports 802.1Q tagging and 802.1ad double VLAN tag (Q-in-Q)

 Ingress/Egress Bandwidth control with 64K granularity

 Supports 802.3ah-OAM loop back and dying gasp (remote power failure detection)

 Supports firmware upgrade via Web

 Supports Digital Diagnostics (DOM) for supported SFP

 Provides product information for management

 Includes RMON counters (stand-alone only)

 Supports password setting for authentication

 Supports Link Fault Pass Through (LFP) Function

 Supports Auto Laser Shutdown (ALS) Function

 Supports DHCP client for automatic TCP/IP configuration

 Supports local and in-band remote management from FRM220 rack management

FRM220-1000MS SFP socket supports a wide range of standard SFP modules to address any network situation.

Single-mode, Multi-mode, Multi-rate, Dual Rate (100/1000), Single fiber bi-directional, Coarse and Dense Wave Division Multiplexing (CWDM

and DWDM) and Copper media

WARNING: Fiber optic equipment may emit laser or infrared light that can injure your eyes. Never look into an optical fiber or connector port.

Always assume that fiber optic cables are connected to an active laser light source.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 45 46

Pas de commentaire

CTC Union FRM220 Manuel d'utilisateur Page 8